CompTIA N10-008 Real Exam Questions
The questions for N10-008 were last updated at Dec 01,2024.
- Exam Code: N10-008
- Exam Name: CompTIA Network+Exam
- Certification Provider: CompTIA
- Latest update: Dec 01,2024
A network technician has multimode fiber optic cable available in an existing IDF.
Which of the following Ethernet standards should the technician use to connect the network switch to the existing fiber?
- A . 10GBaseT
- B . 1000BaseT
- C . 1000BaseSX
- D . 1000BaseLX
A network technician has multimode fiber optic cable available in an existing IDF.
Which of the following Ethernet standards should the technician use to connect the network switch to the existing fiber?
- A . 10GBaseT
- B . 1000BaseT
- C . 1000BaseSX
- D . 1000BaseLX
A network technician has multimode fiber optic cable available in an existing IDF.
Which of the following Ethernet standards should the technician use to connect the network switch to the existing fiber?
- A . 10GBaseT
- B . 1000BaseT
- C . 1000BaseSX
- D . 1000BaseLX
A network administrator is installing a wireless network at a client’s office.
Which of the following IEEE 802.11 standards would be BEST to use for multiple simultaneous client access?
- A . CDMA
- B . CSMA/CD
- C . CSMA/CA
- D . GSM
An engineer notices some late collisions on a half-duplex link. The engineer verifies that the devices on both ends of the connection are configured for half duplex.
Which of the following is the MOST likely cause of this issue?
- A . The link is improperly terminated
- B . One of the devices is misconfigured
- C . The cable length is excessive
- D . One of the devices has a hardware issue
Given the following information:
Which of the following command-line tools would generate this output?
- A . netstat
- B . arp
- C . dig
- D . tracert
A technician is writing documentation regarding a company’s server farm. The technician needs to confirm the server name for all Linux servers.
Which of the following commands should the technician run?
- A . ipconfig
- B . nslookup
- C . arp
- D . route
A technician is installing a cable modem in a SOHO.
Which of the following cable types will the technician MOST likely use to connect a modem to the ISP?
- A . Coaxial
- B . Single-mode fiber
- C . Cat 6e
- D . Multimode fiber
A network device is configured to send critical events to a syslog server; however, the following alerts are not being received:
Severity 5 LINK-UPDOWN: Interface 1/1, changed state to down
Severity 5 LINK-UPDOWN: Interface 1/3, changed state to down
Which of the following describes the reason why the events are not being received?
- A . The network device is not configured to log that level to the syslog server
- B . The network device was down and could not send the event
- C . The syslog server is not compatible with the network device
- D . The syslog server did not have the correct MIB loaded to receive the message
A network technician is observing the behavior of an unmanaged switch when a new device is added to the network and transmits data.
Which of the following BEST describes how the switch processes this information?
- A . The data is flooded out of every port. including the one on which it came in.
- B . The data is flooded out of every port but only in the VLAN where it is located.
- C . The data is flooded out of every port, except the one on which it came in
- D . The data is flooded out of every port, excluding the VLAN where it is located