Cisco 350-401 Real Exam Questions
The questions for 350-401 were last updated at Dec 19,2024.
- Exam Code: 350-401
- Exam Name: Implementing and Operating Cisco Enterprise Network Core Technologies (ENCOR)
- Certification Provider: Cisco
- Latest update: Dec 19,2024
When configuration WPA2 Enterprise on a WLAN, which additional security component configuration is required?
- A . NTP server
- B . PKI server
- C . RADIUS server
- D . TACACS server
Wireless users report frequent disconnections from the wireless network. While troubleshooting a network engineer finds that after the user a disconnect, the connection re-establishes automatically without any input required.
The engineer also notices these message logs.
Which action reduces the user impact?
- A . increase the AP heartbeat timeout
- B . increase BandSelect
- C . enable coverage hole detection
- D . increase the dynamic channel assignment interval
Refer to the Exhibit.
Rapid PVST+ is enabled on all switches.
Which command set must be configured on switch1 to achieve the following results on port fa0/1?
✑ When a device is connected, the port transitions immediately to a forwarding state.
✑ The interface should not send or receive BPDUs.
✑ If a BPDU is received, it continues operating normally.
- A . Switch1(config)# spanning-tree portfast bpdufilter default
Switch1(config)# interface f0/1
Switch1(config-if)# spanning-tree portfast - B . Switch1(config)# spanning-tree portfast bpduguard default
Switch 1 (config)# interface f0/1
Switch1 (config-if)# spanning-tree portfast - C . Switch1(config)# interface f0/1
Switch1(config-if)# spanning-tree portfast - D . Switch1(config)# interface f0/1
Switch1(config-if)# spanning-tree portfast
Switch1 (config-if)# spanning-tree bpduguard enable
Which configuration restricts the amount of SSH that a router accepts 100 kbps?
- A . Option A
- B . Option B
- C . Option C
- D . Option D
Refer to the Exhibit.
A network engineer configures NAT on R1 and enters the show command to verity the configuration.
What does the output confirm?
- A . The first pocket triggered NAT to add on entry to NAT table
- B . R1 is configured with NAT overload parameters
- C . A Telnet from 160.1.1 1 to 10.1.1.10 has been initiated.
- D . R1 to configured with PAT overload parameters
Refer to the Exhibit.
What does the cisco DNA REST response indicate?
- A . Cisco DNA Center has the Incorrect credentials for cat3850-1
- B . Cisco DNA Center is unable to communicate with cat9000-1
- C . Cisco DNA Center has the incorrect credentials for cat9000-1
- D . Cisco DNA Center has the Incorrect credentials for RouterASR-1
Which AP mode allows an engineer to scan configured channels for rogue access points?
- A . sniffer
- B . monitor
- C . bridge
- D . local
Refer to the Exhibit.
What is the effect of this configuration?
- A . When users attempt to connect to vty lines 0 through 4, the device will authenticate them against TACACS+ if local authentication fails
- B . The device will authenticate all users connecting to vty lines 0 through 4 against TACACS+
- C . The device will allow users at 192.168.0.202 to connect to vty lines 0 through 4 using the password ciscotestkey
- D . The device will allow only users at 192.166.0.202 to connect to vty lines 0 through 4
Which technology provides a secure communication channel for all traffic at Layer 2 of the OSI model?
- A . MACsec
- B . IPsec
- C . SSL
- D . Cisco Trustsec
Which line must be added in the Python function to return the JSON object {"cat_9k": “FXS193202SE")?
A)
B)
C)
D)
- A . Option A
- B . Option B
- C . Option C
- D . Option D